Section 4.8
Lifeboats with a self-contained air support system
This content comes from OCR text extraction
The text may contain inaccuracies, especially units and clause numbers. Treat the original scanned pages or the official IMO document as authoritative.
Full OCR text
4.7.3.2 For oi tankers, chemical tankers and gas cannvers with a final angle of heel greater than 20° calculated in accordance with the International Convention tor the Prevention of Pollution from Ships, 1973, 2s modified by the Protocol of 1978 relating thereto, and the recommendations of the Organization,” as applicable, a lifeboat shall be capable of being free-fall launched at the final angle of heel and on the base of the final waterline of that calculation. 4.7.4 Construction Each free-fall lifeboat shall be of sufficient strength to withstand, when loaded with its full complement of persons and equipment, a free-fall lunch from a height of at least 1.3 times the free-fall certification height. 4.7.5 Protection against harmful acceleration Each free-fall lifeboat shall be so constructed as to ensure that the lifeboat is capable of rendering protection against harmful accelerations resulting from being launched from the height for which it is to be certified in calm water under unfavourable conditions of trim of up to 10° and list of up to 20" either way when it is fully equipped and loaded wath: its full complement of persons; 2 oocupants so 25 to Cause the centre of gravity to be in the most forward position; J occupants so 2s to cause the centre of gravity to be in the most ait position; and 4 the operating crew only. 4.7.6 Lifeboat fittings . Each free-fall lifeboat shall be fitted with 2 release systéin which shall: Jl have two independent activation systems for the release mechanisms which may only be operated from inside the lifeboat and be marked in a colour that contrasts with its surroundings; 2 be so arranged as to release the Funder any condition of loading fram no load up to at least 200% of the normal load the fully equipped lifeboat when loaded with the number of persons for which it is to be approved: 3 be adequately protected against accidental or premature use: 4 be designed fo test the release system without launching the lifeboat; and 4 be designed with a factor of safety of 6 based on the ultimate strength of the materials used. 4.7.7 Certificate of approval In addition to the requirements of paragraph 4.4.1.2, the certificate of approval for a free-fall lifeboat shall also state: 1 free-fall certiincation herght; 2 required launching ramp length; and 3 launching ramp angle for the free-fall certification height. 4.8 — Lifeboats with a seli-contained air support system In addition to complying with the requirements of section 4.6 or 4.7, as applicable, a lifeboat with a seli-contained air support system shall be so arranged that, when proceeding with all entrances and openings Closed, the air in the lifeboat remains sale and breathable and the engine runs normally for a period of not less than 10 min. During this period the atmospheric pressure inside the lifeboat shall never fall below the outside © Riker: ev then: cDinnuiggestabidliny “aecglanersestie all thet eneseciticaaall Conk derbi Construction and Equipment of Ships Carrying Dangerous Chemical in Bulk 16 Code) (MSC_4H8)\, as amended) and the International Code for the Construction and Equipment of Ships Carrying Liquetied Cases in Bulk (1G~ Code) (resolution MSC_S/48), as amended atmospheric pressure nor shall it exceed it by more than 20 hPa. The system shall have visual indicators to indicate the pressure of the air supply at all times. 4.9 Fire-protected lifeboats 4.9.1 In addition to complying with the requirements of section 4.8, a fire-protected lifeboat, when waterbome, shall be capable of protecting the number of persons it is permitted to accommodate when subjected to a continuous of fire that envelops the lifeboat for a penod of not less than & min. 4.9.2 Walter spray system A lifeboat which has a water spray fire-protection system shall comply with the following: “ls water for the system shall be drawn from the sea by a self-priming motor pump. It shall be possible to turn “on” and turn “off” the flow of water over the exterior of the lifeboat; 2 the seawater intake shall be so arranged as to prevent the intake of flammable liquids tram the sa suriace and 3s the system shall be arranged for flushing with fresh water and allowing complete drainage. Rescue boats 5.1 Rescue boats = 5.1.1 General requirements a $.1.1.1 Except as provided by this section, all boats shall comply with the requirements of paragraphs 4.4.1 to 4.4.7.4 inclusive (excluding 4.4.6.8), and 4.4.7.6, 4.4.7.7, 4.4.7.9, 4.47.10 and 4.4.9, except that, for all rescue boats, an average 62.5 kp shall apply to paragraph 4.4.2.2.1. A lifeboat may be approved and used as a rescue boat if it all of the requirements of this section, if it successfully completes the testing fora rescue boat required in regulation 114.2, and if its stowage, launching and recovery armangements on the ship meet all of the requirements for a rescue boat. 5.1.1.2 Notwithstanding the requirements of paragraph 4.4.4, required buoyant material for rescue boats may be installed extemal to the hull, provided it is adequately protected against damage and is capable of withstanding exposure as specified in paragraph 5.1.3.3. 5.1.1.3 Rescue boats may be either of ngid or inflated construction of a combination at both and shall: J be not less than 3.8 m and not more than 8.5 m in length; and 2 be capable of carrying at least five seated persons and a person lying on a stretcher all wearing immersion suits and litejackets if required. Notwithstanding paragraph 4.4.1.5, seating, except for the helmsman, may be prowided on the floor, provided that the seating space analysis in accordance with paragraph 4.4.2.2.2 uses shapes similar to figure 1, but altered to an overall length of 1,790 mm to provide for extended legs. No part of a seating space shall be on the punwale, transom, or on inflated buoyancy at the sides of the boat. 5.1.1.4 Rescue boats which are a combination of mgd and inflated construction shall comply with the appropriate requirements of this section to the satisfaction of the Administration. 5.1.1.5 Unless the rescue boat has adequate sheer, it shall be provided with a bow cover extending for not less than 15% of its length. 5.1.1.6 Every rescue boat shall be provided with suffigent fuel, suitable for use throughout the temperature range expected in the area in which the ship operates, and be capable of manoeuvring at a speed of at least 6 knots and maintaining that speed, for a period of at least 4 h, when loaded with its full complement of persons and equipment.